Bow Tow Set Up

BOW TOW SET UP

Here we will show you the right placement and the correct setup for the Bow Tow.

1. Using the “looped” end, attach the bow tow-rope to the bow contact point using a larks head. (see fig. 1)

Figure. 1

2. A larks head is made by pushing the end of the loop underneath the bow contact point and taking the opposite side and threading it threw the loop pulling it tight.
(see fig. 2 & 3)

Figure. 2

Figure. 3

3. Take excess and place in hood hatch, pull the rope tight and make the rope just inside of the hatch seal. Tie an overhand knot in the rope. This allows you to store the excess rope in the hood hatch without it slipping back out. (see fig. 4)

Figure. 4

 

 

 

 

 

***Note, when in compromising situations, it is recommended to store the bow tow underneath the #1 strap for quick access in time of emergency.*** (see fig. 5)

Figure. 5